Interlogix NS4702-24P-4S-4X Command Line Guide Manuel d'utilisateur Page 126

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 434
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 125
-126-
Example:
To enable system-name of LLDP TLV for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp tlv-select system-name
4.2.65.59 lldp transmit
Command:
lldp transmit
lldp LLDP configurations
transmit Enable/Disabled transmision of LLDP frames.
Default:
Both (Tx +Rx)
Usage Guide:
To configure LLDP Tx only mode for specific interface
Example:
To configure LLDP Tx only mode for GigabitEthernet X/X
Switch# configure terminal
Switch (config)# interface GigabitEthernet X/X
Switch (config-if) # lldp transmit
4.2.65.60 loop-protect
Command:
loop-protect
loop-protect Loo p protection configuration
Default:
Enabled
Usage Guide:
To enable loop-protect for specific interface
Example:
To enable loop-protect for GigabitEthernet X/X
Vue de la page 125
1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 433 434

Commentaires sur ces manuels

Pas de commentaire