Interlogix Monitor XL Hardware Guide Manuel d'utilisateur télécharger pdf (Page 58)

54 Monitor ISM/xL™ Hardware Guide

22-0375 rev1.1

Module Power Supply

Normally Open

Common

Normally Closed

TB1

TB2

312 4 312 4

TB5

312

TB6

AC Mains

Earth GND

Auxiliary (+)12VDC

(+)12V

(-) 0V

Data B

Data A

Module

Bus

(SNAPP)

VBUS

TB7

Tamper Input

TB3

TB4

Trouble

Output

(-)

(+)

Battery Connectors

1.0 AMP

Output

(+)

(-)

P10

Manual Battery

Re-start

Battery

reset-able

fuse

Auxiliary power

reset-able fuse

Cover

Tamper

Spring

Module Power

Supply

Anti-Attack Bushing Cap (p/n 364-5102) covers the rear tamper spring. It fits inside an “ O “

Ring Bushing (p/n 364-5103) that fits inside the metal cabinet’s rear wall, anti-tamper spring,

knock-out. Leave the O ring bushing and cap IN if the rear tamper is not used. If the rear

tamper is used, remove the cap and the O ring with the edge of a flat screw driver. Discard the

O ring. Align the cap to insert in the tamper spring, knock-out hole on the control cabinet back.

Screw the cap by its center hole to the mounting surface. Place the control cabinet over it,

allowing the rear tamper spring to fit inside the cap. The cap will insert in the metal cabinet’s

tamper spring, knock-out hole. Complete securing the metal cabinet to the mounting surface.

Rear Tamper on

back of board.

Momentarily jumper

after a battery has been

connected and there is

no AC mains available.



5 digit serial number

to program in Module

Programming

XXXXX

This unjumpered

connector not used.

Do not jumper.

These unjumpered

connectors not used.

Do not jumper.

Factory set.

Do not adjust.

SNAPP

Isolate

Battery

Plug

312

(+)12V

SNAPP ISOLATE: Jumper/short with wire to enable Module Bus (SNAPP) connector 12VDC.

Battery Cable p/n 166-2645



Not used

P3 jumper in = rear

tamper bypassed



Brownout Button: After installation and all power connections are complete, press this button

to establish a frame of reference to detect a brownout.

Button

Wire short

for cover

tamper

spring

operation

only.

AC Mains On

Green LED

Additional Cover

Power On

Green LED

Trouble

Yellow LED

Module Bus

communications Red LED

Processor

OK Green

LED

Slow flash.

Fast flash

with no

VBUS

connected.

Ratings:

North American

Input: 16.5VAC/40VA/50-

60Hz/60W, 50mA

Output: 12VDC

Europe

Input: 230VAC/50Hz, 50mA

Output: 12VDC

Temp for both: -10°C to

+55°C (14°F to 131°F) @

93%

Refer to Installation Instructions P/N 21-3614 for further information.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 64 65 66

Commentaires sur ces manuels

Pas de commentaire

Interlogix Monitor XL Hardware Guide Manuel d'utilisateur Page 58

Commentaires sur ces manuels

Produits connexes et manuels pour Panneau de contrôle Interlogix Monitor XL Hardware Guide