Interlogix MCR300-1T/1S Manuel d'utilisateur télécharger pdf (Page 14)

8 IFS MCR300-1T/1S User Manual

Installing the MCR300-1T/1S

Please follow these steps to install the MCR300-1T/1S:

1. Turn off the power of the device/station in a network to

which the MCR300-1T/1S will be attached.

2. Ensure that there is no activity in the network.

3. Connect the fiber cable. Attach the duplex LC connector on

the network cable into the SFP transceiver.

4. Attach fiber cable from the MCR300-1T/1S to the fiber

network. TX, RX must be paired at both ends.

5. Connect a 5 VDC power adapter to the MCR300-1T/1S

and verify that the Power LED powers up.

6. Turn on the power of the device/station; the PWR LEDs

should light when all cables are attached.

Note: It is recommended to use 1000Base-SX / LX SFP

modules available in the IFS Transmission product line. A SFP

transceiver module that is not supported will not be recognized

by MCR300-1T/1S media converter.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Interlogix MCR300-1T/1S Manuel d'utilisateur Page 14