Interlogix GE-DSH-73 Series Installation Sheet Manuel d'utilisateur

 © 2010 UTC Fire & Security. All rights reserved. P/N 1069666-EN • REV 1.01 • ISS 14JUL10 1 of 13 IFS GE-DSH-73/82 and 82-POE Managed Switch I

192.168.0.100 and the default telnet port number is 23. Then press the OK button. Figure 10: The Connect to dialog window Log on to the Console Make

Figure 11: Login request window Now you can configure the Switch by Telnet. Web Browser Setup Start Web Management The following shows how to start u

Figure 12: IP management diagram PC/Workstation with IE Browser Managed Industrial Switch IP Address: 192.168.0.x IP Address: 192.168.0.100 1. RJ64

Figure 13: Login screen 3. After entering the username and password, the main screen appears. 4. Now you can use the Web management interface to co

System Requirements Your switch is designed to operate with a variety of platforms, operating systems and network cards. Actual performance will depen

Figure 1: Terminal block connectors 2. Tighten the wire-clamp screws to prevent the wires from loosening. Figure 2: Terminal block pinouts

Terminal Setup There are three ways to access and setup your switch. They are: • RS-232 console • Telnet • Web Browser RS-232 console To configure t

• Baud : 9600 • Parity : None • Data bits : 8 • Stop bits : 1 • Flow Control : None Figure 4: COM1 properties window Logon to the Console

Figure 5: GE-DSH-73, GE-DSH-82 and the GE-DSH-82-PoE Login screen Note: For security reasons, please change and memorize the new password after this

Figure 6: IP information screen Configure IP address 1. On the "Switch# " prompt, type "configure" to enter the configuration mo

Figure 7: Set IP address screen 3. Repeat Step 2 to check if the IP address is changed. If the IP is successfully configured, the Managed Industrial

Figure 8: RJ-45 connection diagram PC/Workstation with IE Browser Managed Industrial Switch IP Address: 192.168.0.x IP Address: 192.168.0.100 1. RJ