Interlogix Simon XTi Designer Template Manuel d'utilisateur télécharger pdf (Page 2)

2 Simon XTi Designer Template Installation Sheet

Figure 3: Designer template back

5. Turn over the template to the front (cosmetic) side.

6. Position the two alignment holes in the template (A in

Figure 1 on page 1) over the two pins (C in Figure 2 on

page 1) located on the cover of the panel.

7. Lightly press down on the left side of the template. Once

located, reach under the template and remove the

remainder of the paper backing (F in Figure 3 above).

8. Press down with your thumb on the template from left to

right, removing any air bubbles and ensuring proper

adhesion.

9. After the template is adhered to the front of the panel,

remove protective film from front of template by pulling on

tab (B in Figure 1 on page 1) in upper right hand corner.

10. Replace the plastic trim ring on panel.

Contact information

www.utcfireandsecurity.com or www.interlogix.com

For customer support, see www.interlogix.com/customer-

support

Interlogix is part of UTC Climate Controls & Security,

1 2

Pas de commentaire

Interlogix Simon XTi Designer Template Manuel d'utilisateur Page 2